The digital hurricane tattoo power supply is connected to 220 volts AC voltage, the indicator light is red, turn the voltage adjustment knob clockwise to about 10 volts (depending on personal habits), and then insert the tattoo special hook and the two plugs into the tattoo power supply respectively. (Positive), - (negative) pole, the other two metal hooks are hooked into the two jacks behind the tattoo machine, and then the tattoo foot switch plug is inserted into the power hole next to it, and then the elastic screw on the tattoo machine Loosen, to touch the shrapnel (free of tattoo machine start, if the top is too tight, the tattoo machine is overloaded too much power trip, it is not good for the tattoo machine).
Second, use the foot to lightly press the tattoo foot switch to turn on the power, make the tattoo machine start, and then slowly rotate the elastic adjustment screw. At this time, the working current of the tattoo machine also gradually increases with the contact elasticity of the adjusting elastic screw and the elastic piece. When the tattoo machine is normal, the smaller the current, the better, indicating that the tattoo machine performs well.) Use your fingers to lightly touch the square iron to feel the strength. By continuously adjusting the contact tension of the voltage, the elastic screw and the shrapnel, the tattoo machine has sufficient strength, speed and smooth stroke at the square iron hanging needle. At the best state, the tattoo machine sounds crisp and pleasant, and the long-time work is free of noise. The working voltage adjustment can be adjusted according to the individual's operating habits. The working voltage of the tattoo secant is about 10 volts, and the high point can be adjusted properly when the fog is colored.
Third, the digital hurricane tattoo power supply has overload or short-circuit electronic protection device, due to improper adjustment or power supply hook line unintentional short circuit, the power indicator green light will be on, the voltage is zero, then the power switch button on the tattoo power supply should be turned off. Check the cause, find the cause, then turn on the switch button on the tattoo power supply, re-commission, adjust the screw, and tighten the screw to lock the elastic screw.
