Maintenance of 50MM needle permanent makeup machine
When the tattoo artist operates the eyebrows, eyes, and lip tattoos, there are often two ways: one is a manual knife, and the other is a machine eyebrow machine. The test for the tattoo artist technology is relatively large. Generally, the tattoo artist who is engaged in tattoo work must be equipped with a tattoo machine. After the end of the tattoo work, in addition to doing a good job of skin wound treatment and cleaning the environment, you should pay attention to the maintenance work of the eyebrow machine. Take everyone to know the maintenance knowledge of a machine.
50MM needle permanent makeup machine
1. Clean the machine head. After the tattoo is finished, cut off the power supply, remove the needle and the needle sleeve, and use the disposable needle as much as possible to ensure one person, one needle, one cup and one cap, one color to prevent cross infection. happened. If the prepared tattoo needles and needle sleeves are not aseptically packaged, it is necessary to prepare a disinfectant for soaking, and conditions can also be carried out by ultraviolet steam fumigation. 2. Most of the eyebrow machines currently on the market are plastic casings, so it is not suitable for contact with chemical corrosive agents. It is also not suitable for high temperature treatment. It is also necessary to avoid falls, and put them back into the box in time.
3. The continuous booting time during the tattooing process should not be too long, so as to avoid damage to the motor caused by overheating of the machine. If continuous operation is required, it can be stopped for a while and then turned on. 4. If there is abnormal sound during use, the body shakes, and the speed change fails, stop using it, replace the new machine in time to complete the operation, and do not use it to avoid accidents. 5, many people can't find a special repair point when they encounter problems with the eyebrow machine. In fact, if you buy a brand product, you can find the brand after-sales. If the machine purchased is cheaper, it is recommended to replace the new machine. Because the cost of repair is not cheap.
