There are 4 classic classic thermal papers, white on the top (front) and second on transparent paper to prevent scratches. You can use it, the third one is the paper, and the fourth one is the bottom paper.
How to use the classic thermal paper: Take off the second transparent paper, put the pattern on the transfer paper, and then use the pen to draw on the pattern, so that the pattern will be printed on the reverse side of the first white paper. Cut the pattern according to the size of the pattern, apply the transfer paste on the surface of the skin, and then apply the cut pattern on it, just wait for the pattern to be removed. First measure the half size on the model and mark the opposite point. Divide the area before designing. Copy it with mental classic thermal paper. After the pattern is determined, the drawing is started, then the drawn picture is cut, and some cuts are made in the gap to avoid the discount during the transfer process. All the preliminary preparations have been completed, and the area is divided on the model body, and the following two types are used. The printed products can be mixed and used to achieve the quick-drying and super-sturdy effect. Press the damp paper towel and press on the transfer paper to make the transfer paper fit flat. Leave it for about 10 minutes and the transfer paper is completely dry. It is fine, the transfer paper is torn off in turn, and the transfer is completed. Use the brush to define the primary and secondary relationships, accurately locate the edge line, and the transfer process ends.
