Tattoo machine adjustment method:
1. The transformer is connected to 110 V, 220 V) ac (please note that the switch of POWER behind 110 V to 230 V, choose you want to use an alternating current) to open the POWER switch POWER (1 said connected, 0 means disconnect) indicates the light is red, adjust button VOLTAGF, clockwise rotation slowly, V table (digital display table shows several) will slowly turn (A said only when the tattoo machine work will move), the V table pointer to 6-12 V (note: the voltage is higher, the greater the POWER output, the faster speed.Then insert the plug of the cable into the power hole, and then insert the foot switch into another power hole.
2. Hook the other end of the cable on the eyelet at the end of the eyebrow tattooing machine (insert it into the socket of the tattoo machine), and then press the foot switch to start the tattoo machine.The power lamp is bright red, the V table is between 6-10v, but the tattoo machine fails to start (a. maybe the shrapnel contact is not in place;B. may tattoo machine line disconnect), if it is A need to debug A tattoo machine: the elastic rod from their promptly contact first, then the elastic rod slowly clockwise to promptly contact, at the same time start the pedal switch, make the tattoo machine just started, and then loosen the pedal switch, the elastic rod according to clockwise 180 ° to 360 ° with elastic rod lock screw down the screws.(the transformer has overload protection, when the indicator light is bright green, the voltage is zero, indicating a short circuit, the transformer automatically tripping, at this time to put the POWER switch O to play 1 again, it will restart the POWER supply, voltmeter back to normal).If B, there are several possibilities :1.(2) connect the short circuit, check the plug, hook;(3) pedal switch short circuit. Wire, plug, switch to repair or return to the supplier.
