Double digital tattoo power inspection operation method
First, [commodity description]: The converter and fuse are built in the iron-shell liquid crystal power supply. Input voltage: AC 110 v - 220 v, 50 - 60 hz, output current: 2.
Second, the detection operation method is as follows:
1. Open the package and make the host and the line first to see if the accessories are complete.
2. Plug in the power socket of the host first; make sure that the power switch of the host is turned on after plugging in. If it is in the state of opening first,
You must first plug the power switch off and then plug the power into the power supply (this can avoid short circuit).
3. After the power is turned on, the display frequency will be displayed; the value can be adjusted. Through the above steps, the product can be detected as defective.
Dual digital tattoo power supply
1. Power-on preparation: Plug one end of the randomly distributed AC cable into the power socket on the back of the TM011. As shown in the figure above, the position is inserted. The other end is plugged into the mains.
Socket, insert the foot switch into the jack at the position shown in the figure above. Insert the tattoo machine into the jack at the 2 position shown above.
2. Turn on the power: Step on the foot. The LED lights up.
3. Set voltage: adjust the knob in the 5 position shown above. The output voltage can be set to the required value. After 5 minutes, the power will be automatically turned off.
